TI bq24314, bq24316 Battery Charger Front-end ICs

The bq24314,, by Texas Instruments (TI) (NYSE: TXN), is a battery charger front-end integrated circuit that increases protection when charging a cell phone or other portable electronic device. The 2 mm x 2 mm safety circuits protect a system from input over-voltage, over-current and battery over-voltage conditions, which may result from a power spike during charging, or a defective or incorrect wall adapter. The bq24314 adds extra protection to a lithium battery when a charger circuit fails due to a fault condition. The protection IC can report status of the fault to the host processor, which in turn takes additional corrective actions.

Texas Instruments bq24314 Battery Charger Front-end ICInput over-voltage conditions are caused by steady-state or transient voltage events, such as “hot-plugging” a charged adapter; using a non-regulated or incorrect adapter; or load transients. Any of these events can increase or “spike” the voltage applied to the device and potentially damage the host system. The bq24314 detects the over-voltage level and effectively disconnects the input to the charger to protect the device. The device features an input over-voltage threshold of 5.85 V. Another version of the circuit, the bq24316, supports up to 6.8 V.

Input over-current conditions can occur in integrated power management devices that incorporate a battery charger, which have a direct connection from the input to the system’s bus voltage. Often there is no protection from pulling excessive current from the adapter to the system. The programmable bq24314 limits the input current by sensing and regulating its integrated MOSFET to ensure the system does not pull an excessive amount of current.

Potential hazardous events may occur if single-cell, Li-Ion and Li-Polymer batteries are over-charged beyond their float voltage — typically around 4.2 V. Because of this, portable designers currently seek redundant safety measures to ensure battery safety and compliance. The bq24314 offers a second level of protection that helps monitor the battery’s voltage, and if an over-voltage is detected, interrupts the input charging source.

Key features of the bq24314 and bq24316:

  • Provides protection for three variables: input over-voltage, input over-current and battery over-voltage
  • Integrated power FET and current sensor that supports up to 1.5-A input current
  • Less than 1 us response time against input over-voltage
  • Input over-voltage protection threshold at 5.85 V (bq24314) or 6.8 V (bq24316)
  • High immunity against false triggering due to current transients
  • Status indication – fault condition
  • 30-V maximum input voltage
  • Thermal shutdown

The bq24314 and bq24316 are available today in volume from TI and its authorized distributors. Both devices come in a tiny 8-pin, 2 mm x 2 mm small-outline, no-lead (SON) package. Suggested retail pricing for both in 1,000-piece quantities is $0.75. Evaluation modules of the bq24314 and bq24316, design application notes, and TI’s easy-to-use online power management selection tool are available.

More info: TI bq24314 and bq24316 »